- solid state relay
- Circuit Board Solid State Relay
- Single phase solid state relay
- Industrial Solid State Relays
- Three-phase solid state relay
- Three-phase forward and reverse solid state relay
- Rail type three-phase solid state relay
- Industrial grade solid state relay module
- Tension controller
- Intelligent voltage regulation module
- Single and three-phase silicon controlled trigger
- heat sink
- Semiconductor module, rectifier bridge series
- time relay
- Digital display counter
- water level controller
- timer
- switching power supply
- S series switching power supply
- MS series switching power supply
- LRS series switching power supply
- D, T, Q multi-group series switching power supplies
- DR rail series switching power supply
- NDR rail series switching power supply
- MDR rail series switching power supply
- HDR rail series switching power supply
- FY rainproof series switching power supply
- FS rainproof series switching power supply
- Foot switch
- Fan water pump controller
MXDTR-2410A
Features
?
1. The digital display shows the output voltage;
2. The output voltage can be adjusted when there is no load;
3. There is no output when the control signal is not connected;
4. The control signal is output in proportion to the output voltage, and has good linear symmetry.
?
Model meaning
?
| MXDTR-2410A | Model meaning |
| MX | Corporate logo: MX: Mingxin |
| DTR | Digital tension regulator |
| twenty four | Output load voltage: 0-24VDC |
| 10A | Output rated current value: 10A |
?
Product application
?
This product is mainly used to replace the traditional tension plate and convert the 0-10V voltage signal into o-24V strong voltage to drive the load. Because this product controls the conduction angle of the MOS tube through the power chip to adjust the 24V voltage level, thereby achieving It has a pressure regulating effect, so the product life and stability are much higher than traditional tension plates.
It is widely used in winding machines, magnetic powder clutch tension control, textile machinery, printing machinery, chemical machinery, food packaging machinery, inkjet printing machinery, stranding machines, plate punching machines and other occasions where stepless speed regulation of DC motors/DC fans is required.
?
working conditions
?
1. Power input: 24V DC power supply, the power supply power must be greater than the maximum power of the magnetic powder clutch;
⒉Adjustment method: Manual control: with the help of 3-10K potentiometer; automatic control: the tension sensor converts the tension signal into a voltage signal O-10V, and then the tension adjustment module converts it into a high-power 0-24V signal to drive the magnetic powder clutch.
3. Output signal: 0-24V voltage output, maximum current 4A without radiator, maximum current up to 10A with radiator;
4. Usage environment: working temperature: -10℃~60℃, storage temperature: -40℃~85℃, relative temperature: -5℃~95℃, no condensation.
?
Appearance and installation dimensions/wiring diagram
?
?
Things to note
?
1. A layer of thermally conductive silicone grease should be applied to the contact surfaces of the module base plate and the radiator.
Above 2.5A, a radiator is required. When the current is greater than 10A, please use air cooling or water cooling.
?